Before you replace anything try adjusting the brakes, if you haven't already. I've attached an article and a video on adjusting brakes. In the video skip ahead to about the 4:35 mark to see the adjusting. It can be easier using an Adjustment Spoon # W80630.
If you do need replacement brakes my guess is that you'll need 12 inch assemblies, based on the size of your trailer. However, you'll want to measure to make sure. Measure the insides of your drums like is shown in the attached... view full answer...
The closest thing I was able to find that is to what you're looking for is the:
-Trailer Wheel Center Cap Plug # AM90081.
This wheel center plug will fit center caps that have an outer diameter of 2.95" to 5.15", has an O.D of 2-1/16", and is made from ABS plastic. view full answer...
When loading your bike onto your Hollywood Racks RV Rider Bike Rack for 2 Electric Bikes # HLY64FR, you are going to want to load your bike closest to the rear of the rack closest to the trailer to prevent additional stress on the rack.
Since clearance seems to be a and you're only transporting one bike, I recommend adding a hitch extender like the:
-Roadmaster Anti-Rattle Hitch Extender for Tow Bars # RM-071-1075.
This is going to push your receiver opening for your bike rack out from... view full answer...
Sure!
We have the Solera 20' Sand Fade w/ Black Weatherstrip RV Awning (Std) # LCV000231498 which includes the black roll bar with weather guard stripping.
If you have a black and white trailer, you might consider the:
-Replacement 20' Wide Roller w/ Fabric for Solera RV Awnings # LCV000211517 instead, as this has also has a black roll bar, and the fabric is a black and white fade, which would match really well.
Both of these awnings measure 20' wide, and extends out 8' from your trailer.
I... view full answer...
Yes, the SoftStartRV Soft Start for 2 Air Conditioner Setup # SSR44FR that you're looking at is in fact the newer, smaller version.
These units will allow you to run your ACs on a small generator or simultaneously with small appliances, will reduce the startup power demand on your two air conditioner setup by up to 70%, and, will eliminate that loud clunking compressor noise.
These units will be installed vertically, and include the necessary hardware for installation as well. view full answer...
Thank you for the photos! Based on that it looks like you have a spigot to hub black water tank valve, like you mentioned, where the hub end fits over one pipe and the spigot end fits into the other pipe. So for a spigot to hub replacement valve with a 72 inch cable you will need the following:
- LaSalle Bristol Cable-Actuated RV Waste Valve for Black Water Tank - Spigot to Hub - 72" Cable # 34466N4AB72GMA
Then to complete the install you will just need the LaSalle Bristol ABS Solvent... view full answer...
I got you covered, the correct replacement circuit board for your MaxxFan 4751KS you'll want the Replacement Printed Circuit Board for MaxxAir MaxxFan Plus Roof Vents # MA10A04751KS. view full answer...
Go To Results